Common abbreviations for OBD-II fault codes:

2019-09-17 10:38:46 速銳得 511

Common abbreviations for OBD-II fault codes:

Circuit/open circuit

"Circuit/open circuit" is mostly used when fixed values or high or low detection of specific circuits is not feasible. It can also be used with both low and high fault codes, provided that all three circuit conditions are detectable.

2. Scope / performance

“Range/Performance” means that the circuit is within normal operating range, but is not correct for current operating conditions. It can be used to indicate stuck or distorted values, display circuits, components, or systems that are not performing well.

3. Low circuit

“Low circuit” refers to the circuit voltage, frequency, or other characteristics measured at the input of the control module, which is below the normal operating range.

4. High circuit

“Circuit high” refers to the circuit voltage, frequency, or other characteristic measured at the input of the control module, which is higher than the normal operating range.

5. Row

"Powder" refers to a combination of cylinders that share a common control sensor. The first row always contains cylinder 1, and the second row refers to the opposite row.

6. Sensor location

The "sensor position" is either relative to the engine air flow: from the intake system to the exhaust system, or relative to the engine fuel flow: from the fuel tank to the engine, in the order of 1, 2, 3, etc.

7. Left/Right and Front/Rear

The "left/right and front/rear" positions of the components are assumed to be sitting in the driver's seat.

8. A, B

If the component is represented by a letter (for example, A, B, C, etc.), this is a manufacturer-defined value.

9. Intermittent/unstable

"Intermittent/unstable" means that the signal is temporarily discontinuous, but the duration of the fault is not sufficient to be considered an open or short circuit, or the rate of change is too high.

other:

One more thing to note. The OBD-II system uses a hexadecimal system. It uses 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F to count. For example, the next fault code for P029F is P02A0.


主站蜘蛛池模板: 99精品久久久中文字幕| 久久精品这里热有精品| 精品午夜一区二区三区在线观看| 国产成人免费高清激情视频| 99re在线精品视频| 小丑joker在线观看完整版高清 | 18女人腿打开无遮挡网站| 天天射天天干天天插| 丁香色欲久久久久久综合网| 日本b站一卡二不卡| 久久精品日日躁夜夜躁欧美| 欧美人与zoxxxx另类| 亚洲欧美综合国产不卡| 男人使劲躁爽女人动态图| 农民人伦一区二区三区| 老司机亚洲精品影院| 国产乱人伦偷精品视频免下载| 成人窝窝午夜看片| 国产精品99久久久久久www| 91亚洲精品视频| 在线精品无码字幕无码av| juliecasha大肥臀hd| 岛国视频在线观看免费播放| 中文字字幕在线| 无套内射无矿码免费看黄| 久久亚洲色一区二区三区| 日韩视频在线免费观看| 亚洲一区二区三区在线播放| 欧美性色欧美a在线观看| 亚洲精品99久久久久中文字幕| 狠狠色噜噜狠狠狠合久| 免费看激情按摩肉体视频| 经典三级四虎在线观看| 国产一区亚洲欧美成人| 金8天国欧美视频hd黑白| 国产在线乱子伦一区二区| 99rv精品视频在线播放| 国产热の有码热の无码视频| 你懂的免费视频| 国产精品日韩欧美久久综合| 337p日本人体|